Author Topic: Introducing New Hardware - Amp, Micro Amp - Signal Processor / Amplifier  (Read 15294 times)

Offline jnealand

  • Developer
  • ******
  • Join Date: Aug 2013
  • Location: Kennesaw, GA
  • Posts: 1,932
  • Kudos: 36
Re: Introducing New Hardware - Amp, Micro Amp - Signal Processor / Amplifier
« Reply #75 on: October 12, 2015, 02:30:17 PM »
You resurrecting an old thread.  The original coop has not even been delivered yet.  If you are lucky there may be a few available, but with a coop you must get in while the coop is open.
Jim Nealand
Kennesaw, GA
Lynx, Falcon, XL, FPP

Offline Wolfie

  • Jr. Member
  • **
  • Join Date: Apr 2016
  • Location: Milwaukee
  • Posts: 95
  • Kudos: 0
Since there is a new coop on these...

I wanted to verify that these boards operate on both 12v and 5v pixel lines when placed between chains of nodes?



Offline Setarcos

  • Developer
  • ******
  • Join Date: Jan 2015
  • Location: San Jose, CA
  • Posts: 274
  • Kudos: 6
Yep, the uAmp will work with both voltages. Per the manual, it will accept a voltage of 5-16V.

Offline Wolfie

  • Jr. Member
  • **
  • Join Date: Apr 2016
  • Location: Milwaukee
  • Posts: 95
  • Kudos: 0
Yep, the uAmp will work with both voltages. Per the manual, it will accept a voltage of 5-16V.

Thank you.  Just wanted to confirm prior to hopping into the coop thread.  Am changing most of my stuff over to 12v and doing due diligence prior to ordering.

Offline Wichita

  • Newbie
  • *
  • Join Date: Dec 2015
  • Location: Andover Kansas
  • Posts: 3
  • Kudos: 0

I posted in the wrong thread
« Last Edit: June 14, 2017, 09:22:50 AM by Wichita »

 

Back to top