Author Topic: F4v3 Differential Orientation  (Read 400 times)

Offline twooly

  • Supporting Member
  • ******
  • Join Date: Oct 2013
  • Location:
  • Posts: 996
  • Kudos: 13
F4v3 Differential Orientation
« on: June 12, 2017, 02:28:10 PM »
I'm assuming this is the correct orientation for the board in the slot since it would end up covering an output the other direction?

Connector really doesn't fit  since they are two different types of connectors, and no key like a ribbon cable has.


Offline TravisSlaughter

  • Newbie
  • *
  • Join Date: Apr 2016
  • Location:
  • Posts: 48
  • Kudos: 0
Re: F4v3 Differential Orientation
« Reply #1 on: July 15, 2017, 10:42:45 PM »
That is the same thing i was thinking. Tested and it is correct. I was sweating when I powered it up


Sent from my iPhone using Tapatalk

Offline Bill Thomson

  • Newbie
  • *
  • Join Date: Oct 2017
  • Location: Granite, OK
  • Posts: 20
  • Kudos: 0
    • TPP
Re: F4v3 Differential Orientation
« Reply #2 on: October 28, 2017, 08:57:07 AM »
Connectors are almost always mated pin 1 to pin 1. (There are exceptions.)

Pin 1 can be identified as the square shaped solder pad. (Bottom row, leftmost pin in the photo above.)
Pin 1 of the matching connector on the controller can be identified in the same manner, i.e. square solder pad.

 

Back to top