Author Topic: Linsn RV908 HELP Please Please Pretty Please!!  (Read 73 times)

Offline abrianbaker

  • Supporting Member
  • ******
  • Join Date: Oct 2013
  • Location: DFW - Justin
  • Posts: 103
  • Kudos: 1
Linsn RV908 HELP Please Please Pretty Please!!
« on: December 07, 2018, 07:02:33 PM »
I'll take one more crack at this.

I have a Linsn RV908 that I am trying to configure to run a 4x5 P10 Matrix.  I have researched, read, downloaded and troubleshot everything I can. 

What I am using to set it up: Win 10 PC, Trendnet TU3-ETG USB 3.0 to Gigabit Ethernet Adapter, Linsn RV908 receiving card, D-link GO-SW-8G Switch

Here is where I can't seem to get past:

I have downloaded every version of LED Studio and I cannot seem to get the "Remember Lan" button to un-gray.  I have followed Chris's instructions https://github.com/FalconChristmas/fpp/pull/285/files and no matter what I try I can't get past "Click the "Check Hardware" button.  This should scan the network and change the "Model" value in the upper right corner to "NetCard" if LED Studio can talk to the RV9* receiver card over the network."

Is there anyone out there that can help me with this?!?!

Thank you kindly in advance!! :)

Brian

P.S. For more visibility I will also post on https://www.facebook.com/groups/xLights/



 

Back to top