Author Topic: how many leds before injecting more into the series?  (Read 155 times)

Offline grjmmr

  • Newbie
  • *
  • Join Date: May 2019
  • Location:
  • Posts: 8
  • Kudos: 0
how many leds before injecting more into the series?
« on: May 22, 2019, 03:33:09 PM »
I am using a ready to run falcon controller and I am injecting power through a power supply. looking at buying one or two of the f-8's. So how many pixels will each port of the F-8 inject power into. I currently use 8192 pixels for reference.


Thank you


William

Offline Poporacer

  • Sr. Member
  • ****
  • Join Date: Dec 2017
  • Location: Meridian Idaho
  • Posts: 485
  • Kudos: 6
Re: how many leds before injecting more into the series?
« Reply #1 on: May 22, 2019, 04:23:02 PM »
I think your terminology is off. No controller injects power. They only supply data and normally supply power at the same time. A controller can only supply a certain amount of power and if your light configuration uses more power that the controller (and wiring) can supply, then you can supplement the power through power injection. Power injection is where you will connect power usually in the middle of the string or end of the string. Depending on your configuration, you might have to inject power in more than one place in the string.
If you have an F16 Ready to Run controller, then that is more than enough to control your 8192 pixels. It can handle 16,000 pixels (power injection required) The F8 can control over 5,600 pixels, again, power injection may be needed.
If to err is human, I am more human than most people.

Offline jnealand

  • Developer
  • ******
  • Join Date: Aug 2013
  • Location: Kennesaw, GA
  • Posts: 2,919
  • Kudos: 68
Re: how many leds before injecting more into the series?
« Reply #2 on: May 22, 2019, 06:44:19 PM »
Since this is in the F8 distro seciton and not on the F8 controller section I suspect you are referencing the distro board.  However Rick is correct the F16 will easily handle all your pixels.  If you are like me you will use two power supplies with one connected to the left side and one to the right side.
Jim Nealand
Kennesaw, GA all Falcon controllers, all 12v Master Remote Multisync with Pi and BBB P10 and P5

Offline Poporacer

  • Sr. Member
  • ****
  • Join Date: Dec 2017
  • Location: Meridian Idaho
  • Posts: 485
  • Kudos: 6
Re: how many leds before injecting more into the series?
« Reply #3 on: May 22, 2019, 08:35:24 PM »
LOL, I guess I should pay a little more attention! Oops.
So in regards to how many pixels each port can inject power is a little complex. Each port is rated at 5 amps. Each 12v LED uses approximately .72 watts and if you are using 12V pixels at 100% brightness, constant on, then that is roughly 80 pixels. But they are not always on and you might not run them at 100% brightness

 

Back to top