Author Topic: Pickit3 log file  (Read 683 times)

Offline Jeffl

  • Supporting Member
  • ******
  • Join Date: Dec 2013
  • Location: Brandon, SD
  • Posts: 519
  • Kudos: 4
  • Just remember. Wireless is nice. Copper is king!
    • Christmas In Brandon
Pickit3 log file
« on: December 15, 2014, 10:53:48 AM »
Is there a log file that you can open after you use the Pickit 3 to program a chip?  I have been having issues with programming the Falcon Hub and Etherdongle lately and the little two line window of messages is a pain.  The Pickit 2 was very solid but this v3 you never really know if it's correct until the board works as expected.

Offline jnealand

  • Developer
  • ******
  • Join Date: Aug 2013
  • Location: Kennesaw, GA
  • Posts: 2,883
  • Kudos: 67
Re: Pickit3 log file
« Reply #1 on: December 15, 2014, 11:56:03 AM »
You should be using the IPE function of MPLAB.  It must be easy to use if I can do it.  There is a good writeup on using it in the documentation for the microSC which can be found in that section of the forum.
Jim Nealand
Kennesaw, GA all Falcon controllers, all 12v Master Remote Multisync with Pi and BBB P10 and P5

Offline Jeffl

  • Supporting Member
  • ******
  • Join Date: Dec 2013
  • Location: Brandon, SD
  • Posts: 519
  • Kudos: 4
  • Just remember. Wireless is nice. Copper is king!
    • Christmas In Brandon
Re: Pickit3 log file
« Reply #2 on: December 15, 2014, 12:40:45 PM »
Thanks.  I'm sure it's not hard.  I just needed to read and follow the full document.  The uSC was programmed from the coop so I didn't follow those steps.  And I'll admit I did it the way I had always done it.   Sometimes it's hard to teach an old dog new tricks.

 

Back to top