Falcon Christmas > Falcon Pixelnet to DMX Bridge

RDS output

(1/1)

FireMedic4Christ:
Is the DMX bridge currently the only option to get DMX? I had this when I ran LOR and would like to add it back in.

CaptainMurdoch:
There are a few ways:

- Falcon Pixelnet/DMX (FPD) board on the Pi
- DMX output from a Active Hub
- DMX Bridge
- USB Dongle (Entec Pro compatible or Open)

JonB256:

--- Quote from: FireMedic4Christ on January 07, 2015, 11:24:45 PM ---Is the DMX bridge currently the only option to get DMX? I had this when I ran LOR and would like to add it back in.

--- End quote ---

It may not be the only option but it is a great option. Small and easy to power. The option to control the block of DMX channels or Renard output on 5 different outputs. I used one to greatly reduce long runs of CAT5 when daisy chaining controllers. I was outputting 3 duplicate blocks of channels 1 to 512.

Navigation

[0] Message Index

Go to full version