Author Topic: help converting and stitching four sequences.  (Read 1861 times)

Offline David Pitts

  • Administrator
  • *****
  • Join Date: Mar 2013
  • Location: Falcon, CO
  • Posts: 3,943
  • Kudos: 80
help converting and stitching four sequences.
« on: December 01, 2013, 10:39:32 PM »
Created four video generated sequences, Luke 1, Luke 2, Luke 3 and Luke 4. Light elf opened them and converted them to XSEQ and FSEQ. Wheni play the fseq in the Pi the lights work for first 25 secs or the first sequences data but then lights go out. When I try to convert the xseq or open it in Xlights I get..

"Unable to read all event data from: "then the filename"

Any suggestions
PixelController, LLC
PixelController.com

Offline David Pitts

  • Administrator
  • *****
  • Join Date: Mar 2013
  • Location: Falcon, CO
  • Posts: 3,943
  • Kudos: 80
Re: help converting and stitching four sequences.
« Reply #1 on: December 02, 2013, 12:01:25 AM »
I am going to play a Rosanna Rosanna Dana here and say "Never Mind".

it helps if you save the sequences after the video transitions are applied.

Offline Frankr

  • Moderator
  • *****
  • Join Date: Jul 2013
  • Location: Rocklin, CA
  • Posts: 268
  • Kudos: 0
    • Rocklin Lights
Re: help converting and stitching four sequences.
« Reply #2 on: December 02, 2013, 08:05:31 AM »
Did you take my latest update?  For Fseq exports I was setting the filepointer back to the start of the data before adding each segment so you only ended up with one of the data sets in the output file.

Frank

Offline David Pitts

  • Administrator
  • *****
  • Join Date: Mar 2013
  • Location: Falcon, CO
  • Posts: 3,943
  • Kudos: 80
Re: help converting and stitching four sequences.
« Reply #3 on: December 02, 2013, 02:05:38 PM »
Did you take my latest update?  For Fseq exports I was setting the filepointer back to the start of the data before adding each segment so you only ended up with one of the data sets in the output file.

Frank

Yep 1.0.1. But I was not saving.

 

Back to top