Author Topic: Running Pixcon16 through Falcon F16v3  (Read 170 times)

Offline srtate1

  • Newbie
  • *
  • Join Date: Jul 2018
  • Location:
  • Posts: 18
  • Kudos: 0
Running Pixcon16 through Falcon F16v3
« on: November 02, 2018, 06:36:25 PM »
I spent quite a bit of time getting my LOR AC controller to work through the Falcon.  Now I'm trying to get a Pixcon16 smart controller to work.  The setup is very different, and I'm in the ditch again.  I used LOR Network Configuration to set the IP address of the Pixcon to something near my Falcon.  But I'm not sure how to set up the Adapter/IP addresses for each port via Network Config.  Do I point to the Falcon IP address in that and then connect the Pixcon ethernet port to the Falcon serial port just as I did with the CTB16PC controller?  Thanks!

 

Back to top