FPP Virtual Matrix

[sccrgoalie1]

I have a FPP raspberry pi setup as a virtual matrix remote for my projector.  When it turns on the main player isn't yet running, so it sits at the command prompt showing the IP address.  When the main player starts running, I can see the remote is receiving multicast packets, but it stills stays at the command prompt.  If I simply reboot the remote player, it starts working.  Is there a trick to this?  Running 9.3.

[MikeKrebs]

"stays at command prompt" I assume you mean the hdmi is showing a command prompt? If you HTTP to it, is FPP actually running?

[sccrgoalie1]

"stays at command prompt" I assume you mean the hdmi is showing a command prompt? If you HTTP to it, is FPP actually running?

Yeah, I actually just need to restart ffpd and then it shows the video on the projector.  The hdmi just shows a command prompt until I do that