eFuse configuration

[steve123]

I was reviewing the thread discussing the eFuse configuration:
https://falconchristmas.com/forum/index.php?msg=134141


To confirm my understanding, the intended function for each of the "enablePin" and the "eFusePin" is:
1.  The enablePin is an output connected to the eFuse enable pin
2.  The eFusePin is an input connected to the Fault indication pin on the eFuse device

Is this correct?

Moreover, can one eFuse enablePin be used to control the power to multiple outputs?  That is, can the same enablePin be specified in the output configuration for more than one output?

Also, is it possible to specify multiple enable pin's?  For instance, say there is an enable pin for the eFuse and a separate enable pin for the pixel data output buffer.  The purpose of the pixel data output enable would be to prevent the data output turning on when the power to the pixel strings is off to prevent damaging current flowing through the ESD diode of the first pixel.  Is it possible to specify two pins?

[steve123]

I think I posted this in the wrong forum.  Could/should it be moved to the General forum?