assign wrong protocols with scheduler

[sirloinofbeef001]

I've been trying all day to get the scheduler to work for some testing. When I try to schedule the song or msq. File, it says I'm using d-lights and pixelnet zone 113. Smh. Considering that I'm using pixelnet zone 1 on the sequencer, why would it say d-light zone 1 and pixelnet zone 113?.

[Roger DeBolt]

My guess would be that somewhere you have a controller set to dlight protocol. Can you outpuy from Sequencer ok?  I am not using Scheduler, so not sure how much help I can be here.

[sirloinofbeef001]

both the sequencer and the scheduler is set for pixelnet zone 1 .  Im going to use pi but im waiting on 1 more piece of the puzzle. I just wanted to do some testing while im setting lights up...

[David Pitts]

both the sequencer and the scheduler is set for pixelnet zone 1 .  Im going to use pi but im waiting on 1 more piece of the puzzle. I just wanted to do some testing while im setting lights up...

Check your "Output Configuration" screen in the sequencer and scheduler. Those controller could be listed in there. If so delete them. They will be there if you have ever defined a controller that used that protocol. Even if you change the protocol or delete the controller.

[sirloinofbeef001]

Got it fixed. Had to open the controllers with 7zip search for the wrong controllers which had little to no data on it and delete the ghost controller.     this happens because of making a controller of the wrong protocol by mistake or importing controllers from past sequences not used in your show now. I'm still not 100% sure I did either but this is how you fix it.

[Roger DeBolt]

Glad you were able to get it fixed!