Cannot see FV3 when connected through FPP

[Jonnyoxford]

Good Evening All,

Apologies for asking this as I know it has been done to death but I am stumped. I have FPP connected and accessible through the web browser but I am unable to connect to the controller. Below is my current set up. In the attachments are a load of the other set ups I have attempted. I would greatly appreciate your help.

My current set up is as follows:
Home network router: 192.168.1.1

FPP wlan0:
You cannot view this attachment.
IP: 192.168.1.145
Netmask: 255.255.255.0
Gateway: 192.168.1.1

FPP eth0:
You cannot view this attachment.
IP: 192.168.101.2
Netmask: 255.255.255.0
Gateway: 192.168.101.1


FPP DNS Server:
Server 1:192.168.1.1
Server 2:192.168.1.1

Routing is enabled and in output Enable E131 is ticked and source is set to eth0

F3V:
IP: 192.168.101.003
Mask: 255.255.255.000
Gateway: 192.168.101.001
DNS: 192.168.001.001

Static Routing set up through Linksys WRT1900ACS: 192.168.101.3 -> Gateway: 192.168.1.145

Thanks

[Poporacer]

1. Delete the gateway on your eth0 interface on your FPP device.
2. Change one of your DNS servers to 8.8.8.8
3. Change your Gateway on your F16? to 192.168.101.002
4. Delete/Change your route in your router destination to be 192.168.101.0

That should get you close

[Jonnyoxford]

1. Delete the gateway on your eth0 interface on your FPP device.
2. Change one of your DNS servers to 8.8.8.8
3. Change your Gateway on your F16? to 192.168.101.002
4. Delete/Change your route in your router destination to be 192.168.101.0

That should get you close

Sorted! That was easy. Thanks

[Poporacer]

Glad it worked!