Stand Alone Mode - Wifi

[VdubBry]

Hello all,

It's been awhile, but I dug out my F16V3 box, that is running V2.56 firmware and I wanted to run it in stand alone mode where running an Ethernet cable isn't the best option.  Just to run some color washes etc on some props.  I'm very rusty with this box and I see where I put the box in to stand alone mode, but once it's in stand alone mode do I lose the access to ethernet?  Also, I don't see any options for Wifi, do I need an additional module to run wifi on this board?

I have a couple Raspberry Pi boxes, I could get out and configure if need be, but I am just looking for something quick and simple so figured the Falcon Stand alone mode would be best.  I can't seem to find any documentation about the wifi portion as well.

Thank you!