Schedule Issue by Design or Bug?

[JonD]

If I adjust the schedule start time and save, it automatically reloads and adjusts the start time as expected.  If the schedule is running and I adjust the end time and save, it reloads and does not change the stop time.

Is this by design or a bug?  I would like to adjust the show end time for testing end of show variables. 

UPDATE:  It must be by design as once the schedule is running, you can't change the start time either.   Is there a way to adjust the time after it has been started, other than stopping it and starting all over? 

You cannot view this attachment.
You cannot view this attachment.
You cannot view this attachment.
You cannot view this attachment. 
You cannot view this attachment.
You cannot view this attachment.
You cannot view this attachment. 

[jnealand]

To my knowledge it has never been possible to change the schedule with out a stop and start.  For testing leadin and leadout stuff, I create a test playlist with only a pause for the playlist items.  I can then run that playlist manually from the status page.

[JonD]

Thanks Jim!

I did find that the end time can at least be adjusted.  I have a "Big Button" setting that will extend the schedule 15 minutes when I press it.  I figured if it could be extended there might be a way to shorten it.

The Big Buttons command will not take a negative number, but the FPP command will.  Instead if entering a positive number, enter a negative number to reverse it.  It was one of those things that sounded better that it actually was.  It was easier just to schedule the show to quit 5 minutes after it started.

You cannot view this attachment.
You cannot view this attachment.
You cannot view this attachment.