Firmware update

[Trixie21]

About to update some of my V3's and not sure how to save my current configuration?

Factory Reset (Needed when updating from 2.0x )
1) Save settings to file to reload after update.

[JonD]

There should be a place on the Falcon GUI (webpage) that you can down the the existing configuration.  Seems like it is on the main status page on the upper right hand side, but it has been a while since I have seen it.  If your firmware is older than 2.55, I would upgrade to 2.55 first, and then upgrade to 2.59 after that.  Many people have had issues trying to go straight to 2.59 when their firmware was older than 2.55.  It would not boot after the upgrade.

2.55 Link
https://www.pixelcontroller.com/firmware/f16v3/F16V3_2_55.zip

2.59 Link
https://www.pixelcontroller.com/firmware/f16v3/F16V3_2_59.zip

Manual shows it being where I thought it was.  See Below.
You cannot view this attachment.

[Trixie21]

Thank you so much. That is what I was looking for!