Can 7.3.5 run ETH0, ETH1, and Wifi?

[dennismccreery]

I have a Pi remote that's running 7.3.5 and can't, for the life of me, get all three networks active.
It's running ETH1 to a Colorlight which appears to work fine, and when I hook up ETH0 to the show network
I can get to the FPP instance just fine.  But if I unplug the ETH0 cable, even after power cycling, there's
no Wifi connection.  Here's the config: 

You cannot view this attachment.

You cannot view this attachment.

You cannot view this attachment.

Thanks,

Dennis the Menace

[Poporacer]

You only want one interface to have a Gateway defined, and that is typically your Wi-Fi

[dkulp]

You also don't want two interfaces on the same subnet.   

[dennismccreery]

But I have only one wireless router, with the default subnet of 192.168.29.XX and a subnet mask of 255.255.255.0.
How could I set the Wifi up on a different subnet and have it still work with my router?

Regards

Dennis the Menace

[Poporacer]

But I have only one wireless router

Are you going to connect to this subnet via Wi-Fi or wired....You have to decide which one and use that one.

How could I set the Wifi up on a different subnet

If you are connected to your home network via cable, then you don't need the Wi-Fi

[dennismccreery]

Seems kind of odd that the ETH0 and WLAN0 have to be on different subnets.
But I guess that's the  way of the world.

Thanks,

Dennis the Menace