Abnormal conditions - May cause poor performance

[Douge75]

UDP Output set to send data to myself. Disabling (IP Address)
 I get this error.
I am using a RPI 4 and FPP 6.0 in Player mode and A Falcon F4V3 controller.

When I'm in FPP Connect what should I set UDP Out to..?
All, None or Proxied.
I selected All .

Your assistance in helping me solve this problem would be greatly appreciated.

Thanks,
Regards,

Doug75

[rudybuddy]

From the Manual:
The UDP Out dropdown will enable xLights to upload The E1.31 and DDP Channel Output definitions from the Setup Tab in xLights. 'All' will uploads All the E1.31 and DDP Channel Output Definitions, 'Proxied' will only upload E1.31 and DDP Ouput Channel Definitions of proxied controllers on that FPP instance. 'All' should be selected on Standalone/Master FPP Devices and 'Proxied' should be used for Remote FPP Devices that act as a tunnel to other controllers like a F16v

[Douge75]

Thanks for the early reply.
Doug75

[Poporacer]

When I'm in FPP Connect what should I set UDP Out to..?

It would depend on your overall configuration, controllers, using MultiSync, using E1.31/DDP?
We need more info in order to answer that question.
But based on my best guess, I think you might have your FPP listed as a controller in xLights? If so, is it actually acting as a controller? (meaning that you have pixels connected directly to your FPP?) 
If your FPP is being used as a controller, then set the Active status in the xLights controller page to xLights Only, otherwise delete the FPP from the Controllers page.