Default Port Brightness Setting for F16V3

[ukkeef]

Hi, hope all is well with everyone. I have a stupid question regarding default Port Brightness. On the controllers page in Xlights I have set a figure of 30%. For Each of my props in XLights I have then set 100% for seed LEDs and 30% for bullet Leds. How does this work? Do i only ever get 30% brightness as a maximum for the seeds and only 9% for the bullets? Am I better setting the default to 100% and then setting the props to either 100% or 30% depending on the LED type?

Thanks in advance for any advice

Keith

[JonD]

There is only 1 default brightness setting, but you can go to the individual string in xlights and override the setting per indiviual string.  I would default to the most common setting, and only change what you need to.  This is assuming the seeds and bullets are on different ports.  It seems like you can only have one brightness setting per port.

[Poporacer]

It seems like you can only have one brightness setting per port.

If the controller supports virtual strings then you can have different brightnesses per model. 

[ukkeef]

Thanks for your replies

Keith