Server migration complete, Welcome to version 2.1.1



Welcome, Guest.
Please login or register.
Forgot your password?

+-Site Stats

Total Members: 15648
Latest: zj023
New This Month: 53
New This Week: 12
New Today: 3
Total Posts: 128304
Total Topics: 15779
Most Online Today: 52
Most Online Ever: 7634
(January 21, 2020, 02:14:03 AM)
Users Online
Members: 6
Guests: 31
Total: 37

F16 V3 operational temp range question

Started by tirebytrlights, November 24, 2022, 10:45:56 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.


I have a question on acceptable thermal levels for a F16V3 board. I live in SW Florida, so temps never moderate very much; I have 75 degree nights frequently in December, so I am concerned about temperatures of any outdoor electronics, especially enclosed ones.

I just moved the controller into a Bud NBF32026 box from a 1500 case, I have in and out Bud vents and a 40 CFM fan sucking air inward. The old 1500 had a 25 CFM fan blowing directly onto the controller and with that I would normally see temps reported in the high 80 degree range while operational. While verifying the final build of the new case, after idling 90 minutes or so, the temp got to near 100 degrees as reported by the controller web interface. I am assuming there is stagnent air around the board, so I have some small form-factor fans on order to stir things up directly over the controller. Also, not sure if i should add some heat sinks along with the fans.

My question is what is the normal operational range for the F16V3? The two sensors report values that are within a couple of degrees so probalbly close to accurate. I don't have a thermal camera to verify actual processor chip serface levels. What should I expect at operation times? What is the highest temp I can operate at without worry?


There are no official temperature specifications that I am aware of for the F16v3.  I have CG1500 boxes and mine usually run around 40f-50f degrees higher than the outside temperature.  In general, you want to keep most boards under 50*C/122*F for maximum life.  Anything over 60*C/140*F is cause for concern, but could be fine provided the board was designed for that much heat.


Thanks. This gives me some hope I can keep my controller from self destructing in the heat. Fans I ordered should be here Tuesday and I'm a bit late in deploying everything so it should come together at about the same time.

Support FPP

+- Recent Topics

Trying to configure LOR CF50D Floods on FPP Pi Player with PiCap by tbone321
Today at 12:36:16 PM

raspberry PI 3 / PI 4 by mrfix1
Today at 07:13:55 AM

help getting started, next step? by K-State Fan
Today at 04:42:36 AM

Bug in newest release by tbone321
January 26, 2023, 06:14:26 PM

Cannot Connect to F48V4-NS Through Rasberry Pi by Poporacer
January 26, 2023, 03:13:43 PM

new piCaps in the works? by Bwinter
January 26, 2023, 11:25:32 AM

DIY voucher request by CaptainMurdoch
January 26, 2023, 11:14:38 AM

Which volume to grow during setup? by RickR
January 26, 2023, 09:55:17 AM

F16v3 Won't boot or power on by chiefwarrant
January 26, 2023, 06:56:34 AM

Simple single Channel DMX Output trigger by
January 26, 2023, 05:33:54 AM

Powered by EzPortal
Powered by SMFPacks Menu Editor Mod