Difference on Channel output > LED Panels between two FPP instances

[k6ccc]

This is new.  I have two FPP instances that are almost identical.  Both were updated today from yesterday's master to todays: v8.x-master-304-g3005caa4 (master branch) 
Both are PocketBeagles each with a PocketScroller driving a matrix panel - 2H x 3W P5 for one and 3H x 4W P10 for the other.  On the P10, the Channel Output is the same as it has been with a LED Panels tab.  However now on the P5, the LED Panels tab is replaced with a PocketScroller tab with different options as shown below:
If your  browser does not imbed the image, here is a direct link to it:
http://newburghlights.org/images/FPP_Channel_Output_difference.png

[Poporacer]

However now on the P5, the LED Panels tab is replaced with a PocketScroller tab with different options as shown below:

If the cape is a PocketScroller, then this is the expected behavior.

On the P10, the Channel Output is the same as it has been with a LED Panels tab.

I believe that you have to install a virtual EEPROM on the PocketScrollers since the PocketBeagles do not have a physical EEPROM onboard.

[k6ccc]

If the cape is a PocketScroller, then this is the expected behavior.

It is a new behavior if that is the case - which is fine.

But why only one of them?  As far as the Beagle and scroller, the two are identical.

[Poporacer]

But why only one of them? 

Maybe in the rebuild process or something else the Virtual EEPROM got deleted?