What am I missing - FPP 8 artnet input configuration

[mrcorbu]

Hey everyone, I have this setup going :
Rasbpie 3 + M4PIE Hat
1x WS2812b 16x16 LED matrix

My panel work fine using FPP test feature, but wont receive any artnet data.
FPP is setup in Player mode.
FPP is on latest version 8.0.

I have done test using Resolume arena and Jinx!
My laptop and the pie are both on the same Wireless network ( 192.168.1.0/24 )
I can ping and control my FPP controller via my laptop.
I have disable my eternet card to make sure the data is going out on the wireless card.

I am looking for pointer of what to look for.
Is using 2 universe of 512 by spliting my led matrix in 8x16 is correct ?
Is wireless lan an issue ?
How can I confirm from FPP that it is receiving artnet data ?


Any pointer or tips welcome, Thank you for your time, let me know if I am missing any other usefull information.

Here some config attached.

You cannot view this attachment. You cannot view this attachment. You cannot view this attachment. You cannot view this attachment. You cannot view this attachment. You cannot view this attachment. You cannot view this attachment.

[dkulp]

You didn't click on the "Enable Input" checkbox. 

[jnealand]

You didn't click on the "Enable Input" checkbox.

Been there, done that and I'll bet a lot of others have done that also.

[mrcorbu]

  Wow, I was so relieved that it was that simple. It still stings a bit, though. Thanks for the quick reply; everything is working fine