some props aren't working

[aquinones3]

So I'm having a problem with my roof line. On my over entry I have it split in the middle with the snowflake in the middle starting the left side of the roof. Approximately 205 pixels on one port on a smart receiver v.2. and a lower roof line does turn on either. So the right side of my display is all on and the left side on the upper splits at the over entry. When I test the lights one my f16 controller everything works, but on fpp that happens any clue what I can try next?

[tbone321]

That sounds like a configuration issue.  If you could post a few screen shots of your configuration for the controllers as well as the XLights configuration of the props, it would help us to see the issues causing this.

[MikeKrebs]

I second a config problem.

How did you do the configuration? 
Did you upload it from xLights or are you setting it manually. 
Screen shots of both FPP and your F16 controller please.

[aquinones3]

You cannot view this attachment.

[aquinones3]

You cannot view this attachment.

[aquinones3]

You cannot view this attachment.

[aquinones3]

I upload through fpp connect, what do you need to see on the fpp?

I'm sure its something with fpp cause when I test on the falcon everything works when I test on fpp I get these problems

[MikeKrebs]

The channel output page. Should match to your configuration.

[tbone321]

In FPP we would need to see the Channel Outputs screen.  I am also seeing some red in the controller configuration for the first 16 ports which indicates something is not defined correctly.  As for XLights, if you could, post a screenshot of the prop configuration page.  The visualizer page doesn't show the channel numbers assigned to the props.

[aquinones3]

You cannot view this attachment.

[aquinones3]

I'm only using 3 ports on my f16v4, its mounted in the garage then I daisy chained 3 smart controllers.

[tbone321]

Your not sending all the data that the controller needs.  If you look at your controller configuration, it is showing the highest channel as 6580 but if you look at the FPP output definition, you are only sending 5611 channels worth of data.  The first thing that I would do is increase the universe count in the FPP output channels to 13 to make sure that it is sending all of the data required.

[aquinones3]

ill try that

[aquinones3]

You cannot view this attachment.

[aquinones3]

You cannot view this attachment.