RESOLVED - Error : "Received bridging data while sequence is running"

[augustinm]

I am running K32 controller as FPP master. I am also running a K40-PB as FPP Remote. Both of them are in version 7.5.

When I run a sequence in master, it runs in the remote as well which is good news. However, I noticed two things.

1) Pixels relating to K40-PB remote are frozen for a second or so when the sequence starts. After that, they are ok and in sync with the pixels in the master.
2) While the sequence is running, I see the below error in the FPP remote of K40-PB.

Abnormal Conditions - May cause Poor Performance
Received bridging data while sequence is running

Hopefully, someone can help me. Thanks!

[augustinm]

Duh! In the channel output of the FPP Master, I had the FPP remote also selected. As soon as I unchecked this, this problem went away.

[TheMinionHouse]

I am getting this error too.  and I don't see anything on the master that says remote, at all. 
what am I missing, my configuration has not changed in the last 2 years. 
Only did the in place updates.  
I  have my Master and 4 Controllers, and 15 FPP remotes, and Not all of them are giving me the error. 

[JMHaro]

I'm also getting this same error and haven't figured out how to get rid of it.

[Poporacer]

I am getting this error too.  and I don't see anything on the master that says remote, at all. 

This error means that a device configured to be a Player is receiving data from another source trying to tell it what to do. This is not a good thing to have 2 bosses trying to run a show.

This could be caused by a few issues. Outputting from xLights, a device configured to output data when it shouldn't be. And sometimes that can be created by an incorrect configuration in xLights.