FPP 6.2 ColorLight Issues

[Poporacer]

I also had issues running in multisync and remote, could not get anything to work,

Usually this is due to a configuration issue or poor network connectivity. There are hundreds, if not thousands of people successfully using Multisync with remotes.

But the best method is the one that you understand and can make work for you.

[LedMutt]

But the best method is the one that you understand and can make work for you.

Yes, I've read many post about people running their show in a multisync-remote setup, for me that did not work, even got some high gain antennas...

[dennismccreery]

No joy.  However, now I'm seeing a different error message:

2022-12-22 15:30:56.439 (1686) [ChannelOut] /opt/fpp/src/channeloutput/ColorLight-5a-75.cpp:280: Error getting index of eth1 interface: No such device

2022-12-22 15:30:56.479 (1686) [ChannelOut] /opt/fpp/src/channeloutput/ChannelOutputSetup.cpp:351: Determined range needed 0 - 7

Not sure where to go from here.  Rebooting fixes it.

Set the reboot delay to 30 seconds and it hasn't failed yet.  Keeping fingers crossed.

Regards,

Dennis the Menace