FPP MIDI plugin installed but wont trigger Playlist

[MichaelGilley]

I am new to FPP and all things lighting so bear with me. I have FPP 9.5 installed and the FPP Midi plugin. I have a Arturia Minilab plugged in and the plugin see the device, and I can receive commands from the midi device. The issue comes after that. I can't seem to get the key press to trigger anything. I would love to just be able to trigger a playlist. 

I have a small test rig setup in my office you I only have 1 wled controller setup (Dig Uno) with 2 small led strips on channel 1 and 2. Everything has a static IP address. 

FPP 192.168.8.2 
Dig Uno 192.168.8.163

Does anyone have an idea or a place I can look to figure this out. I would really appreciate any help at all. I'm sure it's something simple or a misconfiguration on my part I just don't know where.  

Thanks

[MichaelGilley]

OK, everyone. I figured it out and just wanted to reply to this tread in case it could help someone else. 
I ssh into the pi and ran the following commands. aseqdump -l which listed out the devices I had connected to the PI along with their ports. Then I ran aseqdump -p {port} and could see the Midi commands coming in. That when I realized that instead of using hex ( 0x30) I should have been using the decimal 48 in the plugin. After that I was able to get it all up and running. Like i said in the earlier post, I'm a beginner and I figured it was a simple mistake. Hope this helps someone else. 

[MikeKrebs]

Thanks for the followup.