Falcon Christmas

Other Controllers and Hardware => Legacy Controllers and Hardware => µ (Micro) Hardware - µSC, µAmp, Afterburner => Topic started by: lrhorer on August 10, 2017, 01:39:01 PM

Title: Layout for uAmp
Post by: lrhorer on August 10, 2017, 01:39:01 PM
Corey,

    I believe some of the dimensions have changed on the new uAmp board.  Have any of the solder pads moved in relation to the others?  I am preparing to order a batch of my motherboards from the fabricator, but I will need to change the design a bit if any of the solder pads in the uAmp have moved in the new design.
Title: Re: Layout for uAmp
Post by: corey872 on August 11, 2017, 08:00:42 PM
Not sure what you are considering "new" -- The V2 board or the 2017 production run?

V1 to V2 there was a change in some hole diameters and layout and I suppose some of the solder pads changed too.

2016 V2 to 2017 V2, there are not 'supposed' to be any changes, but the only way I could guarantee would be to have a board in-hand, so if it is something exactly critical, you might wait to have an actual board.
Powered by SMFPacks Menu Editor Mod