Remote script issue

[mac1321]

Running 6.2  with 1 master and two remotes.  All where fresh new installs this year.  Light show works and my projector on the remote run's videos no problem with my sequence.

The issue I am having is if I use the projector plugin scripts to power on and off the projector, I have no issue.

When I try to use run remote script and put the script name in and the IP address of the remote that has the scripts and the projector attached the script never runs.  So, I am stumped and stuck. 

Any ideas or suggestions?  Below is my lead in and my lead out is just the power off script being run the same way,

[darylc]

does the script work when you run it directly from the remote?

[mac1321]

Yea it works fine when run on the remote pi directly.  Just can't trigger it to run from the master now.

[Aaron Maue]

I know this thread is getting a little stale, but in case you're still checking, here's a possible workaround...

1.  On the remote, create a command preset that fires the script.
2.  Instead of trying to launch a remote script from the player, launch the remote command preset.

I'm not a dev, but I'm thinking it should work the way you're trying to do it.  In the meanwhile, however, maybe this will get you rolling.

[jnealand]

I had a similar problem trying to turn my static TuneTo on and off.  The scripts worked great if run from the remote, but not when triggered from the master in my leadin and leadout.  The problem is the the command needed a fully qualified script name.  ie.  I had to add .sh after the script name.  Once I changed StaticOn to StaticOn.sh  it worked just like I wanted it to.