ELM (Enttec LED Mapper) and FPP with bare RPi questions

[ericjforman]

Hi all, new to FPP so hello! (although very experienced with LED mapping and controllers). I'm using a bare RPi Zero 2 with FPP (i.e. direct to GPIO), connected by WiFi. I'm trying to get input LED data from ELM (and eventually record via ethernet, but that's another topic). 

First off, I assume that in Cape Config, I should use the PiHat setting as a kind of generic RPi choice, although the manual doesn't explicitly say that. 

I set Input to ArtNet, and Output to my string specs. FPP Testing mode of the pixel string works.

I am unable to get input from ELM however.

To send ArtNet or sACN from ELM, the WiFi adapter settings are 
10.105.44.69
"broadcast to 10.105.47.255"

My RPi has a static IP of 10.105.32.100.

There is no way to set the adapter IP in ELM manually, AFAIK.

What's the proper way to do this?

Thank you!

You cannot view this attachment.

[ericjforman]

I should mention I don't have access to the router or switch, so I am connecting directly. For simplicity, we can use the ethernet config: connecting directly to the computer, no router. (I have both wifi and ethernet setup on the same FPP/RPi).

FPP/RPi eth0:
192.168.0.100
Gateway: none (not allowed to have more than gateway)

Computer with ELM (Enttec LED Mapper):
192.168.0.50
Gateway: 192.168.0.1

Enttec ArtNet output, unable to change:
192.168.0.50
broadcast to 192.168.0.255

What's the next step?