DDP or E1.31

[bowhunter3125]

I have a Baldrick 8 port controller hooked to a Falcon F16v4, the controller is  DDP only controller, I at first set the Baldrick output on FPP to DDP however none of the lights would work, when i set it to E1.31, I now have control over the lights, i am assuming this is ok? but i noticed tonight that during testing all my lights off the baldrick worked fine weather testing from the controller or from the PI, but when i run a sequence, only 14 of the 20 RBL's will light up. i checked the sequences, all seem fine when viewing them in Xlights, Am i missing something? 

[MikeKrebs]

Sounds like configuration. What do you have inside your RBL? What is the config in xLights? What does the config say in FPP?

[bowhunter3125]

in xlights i have it set at 1 string 20 pixels then when i had the string on a falcon i had group count at 12, but now that i have it coming from the Baldrick i am unable to set the group count.

[Poporacer]

the Baldrick i am unable to set the group count

Group Count is a function of the controller, just like Null Pixels. It sounds like the Baldrick might not support a Group Count?

in xlights i have it set at 1 string 20 pixels then when i had the string on a falcon i had group count at 12,

How did that even work? 20 pixels is not evenly divisible by 12?

[jnealand]

Not Baldrick specific, but group count exerience.  I have 12 Boscoyo Pixelaria all daisy chained on one port.  Each Pixelaria has 5 nodes in each.  In xlights I set up as 12 nodes with and group count of 5 in the controller.  No success then set it as 60 pixels with a group count of 5 and thought that would take care of everything, but it did not.  Appears that just impacts xlights sequencing since I still have to indicate on the controller that I have a group count of 5.  Sounds like something similar to your use with the RBLs.

[Poporacer]

Appears that just impacts xlights sequencing since I still have to indicate on the controller that I have a group count of 5

This setting in xLights is a Controller setting and you have to upload the controller config from xLights for it to take effect in the controller.

[bowhunter3125]

the Baldrick i am unable to set the group count

Group Count is a function of the controller, just like Null Pixels. It sounds like the Baldrick might not support a Group Count?

in xlights i have it set at 1 string 20 pixels then when i had the string on a falcon i had group count at 12,

How did that even work? 20 pixels is not evenly divisible by 12?

Each puck is treated as a singke pixel in xlights, buy under co troller connections you set the group to 12 cause each puck is 12 led's.  I have 9 rbl bulbs that are 9 pixels but group count is 9 cause unhsve 9 pixels in each bulb. 

[bowhunter3125]

I got it figured out, forgot to change the universe count from 512 to 510