FPP Output Setup Not Visible - HELP!

[anthonyfain]

I've recently upgraded to a Falcon F16V5 controller and new Raspberry Pi 5. In the process of reconfiguring the universes of the props and debugging the addressing, the Output Setup in FPP is no longer visible.... HELP!

[jnealand]

Every time any of my controllers look like that it has been because I misconfigured the controller setup in xlights or because I forgot to do the upload to controller from xlights.  YMMV

[anthonyfain]

Update: I'll mention that this is the first time that i've done full controller configuration in xlights (typically i've manually addressed everything). Even without the ability to assign the E131 output in FPP, my sequences are working just fine...

[Poporacer]

the Output Setup in FPP is no longer visible

I am not sure what you mean by this, the screenshot shows your outputs setup section. Are you expecting to see the data for the F16 in that page? If so, then in FPP Connect, set the UDP Outputs to All.

[anthonyfain]

Previously I would need to add the controller IP address and universe #'s. Surely this is just my inexperience.

[Poporacer]

Surely this is just my inexperience.

Likely and we have all been there. Did you try my suggestion about FPP Connect?