Aurora and SRx2 LR Reeiver

[jwblazek]

I added an Aurora and a SRx2 this year.
I have the switch set at "A" and all four of the "a" outputs work fine

I cannot get any of the "b" outputs to work, they display only a pale blue on the pixels

What am I missing?

[allknowing2012]

I added an Aurora and a SRx2 this year.
I have the switch set at "A" and all four of the "a" outputs work fine

I cannot get any of the "b" outputs to work, they display only a pale blue on the pixels

What am I missing?

Might you have the terminators ON on the A board?

[jwblazek]

If you are referring to the 4 dip switches, they are all set to on

Which ones do I turn off??  At the moment, using all four outputs of "a" and only 1 of "b"

I just attempted turning 1, then 2 then 3 then all 4 off, same issue

HOWEVER, was switching termination on the fly (sequence running) not certain if it likes that

[allknowing2012]

The last board on a chain has them ALL on any other board has them ALL off.

[jwblazek]

Sorry, only have the ONE SRx2 in this chain, with ALL on, the "b" channels do not work, pale blue output only on all pixels