K8-B not working with SRx2 Differential smart receiver.

[r0ckms0ckm]

I decided to expand my light show by adding two differential receivers. 

My setup:
K8-B -->Expansion port 9-12 -->SRx2 V4 (8 port)
        -->Expansion port 13-16 -->WB4PD V1 (4 port)

The WB4PD V1 seems to be working fine. The SRx2 is not working as expected and it is likely related to my setup.

Both ports 1 and 2 on both id's are working fine but 3-4 on both id's are not. and when I test 1A both 1A and 1B light up, same with 2A and 2B, but 3 and 4 on both ports don't work at all. I have the termination switched turned one because its the last (and first) in the chain and the id selector is set to A, although it doesn't seem to matter what id its selected to.

The Kulp lights page says it works with the beaglebone black and k8-b and the k8-b is on 9.3 with all the updates. before I updated I had 7.3 and it wouldn't work then either. It might be because it only has smart receiver v2 but 9.3 also only has v2 but the page said fpp would work with it. 

Here is my setup
You cannot view this attachment. You cannot view this attachment. You cannot view this attachment.

[allknowing2012]

Try setting dial to 1 on both .. if that doesnt work try setting to 4 on both.