Wifi on Beagle Bone WB48

[blinkyfort]

Hello,

I'm looking for some help setting up my WB48 to use a wifi adapter.

Device: Wally's Lights WB48 Controller

Version Info
FPP Version:	7.5
Platform:	BeagleBone Black
FPP OS Build:	v2023-12
OS Version:	Debian GNU/Linux 11 (bullseye)
Hardware Serial Number:
Kernel Version:	5.10.168-fpp
System Boot Time:	2024-03-03 16:12:15
fppd Uptime:	02:21:11
Local Git Version:	eacc0bd ChangeLog
Remote Git Version:	eacc0bd

The wifi adapter is just one I had around the house, EDUP AC600M USB WiFi Adapter
If I use the FPP Gui and configure the SSID and WPA key, it won't connect.
If I SSH into it, I get 'no result' scans.

Is it the wifi adapter?
Is it WPA listed vs WPA2 my router is running?
Is there another method to configure the wifi? Every time I try to enable the wifi in SSH, I get a 'SIOCADDRT Operation not permitted' via the 'sudo ifconfig wlan0 up' command.

[Poporacer]

The wifi adapter is just one I had around the house, EDUP AC600M USB WiFi Adapter

This might be an older Wi-Fi adapter that Linux no longer supports.  I had to replace several of mine for that very reason.
You might have some luck by adding a boot delay if your Wi-Fi adapter takes longer to get recognized.

Every time I try to enable the wifi in SSH

That isn't needed and not recommended.

[Sawdust]

Many EDUP (and many others) wifi adapters at not LINUX supported.  FPP requires LINUX supported devices.

[blinkyfort]

A new wifi adapter did the trick, and it was basically plug and play. I used the wifi adapter Wallys calls out for the board. https://amzn.to/3NEpM8E