PiCap-V2 String port webpage display issue

[CottonHeadedNinnyMuggis]

I am having a issue with the PiCap-V2.

This is a new PiCap, Installed on a 3B+ running FPP V7.4.

On the initial boot, (the output page) showed all 4 string ports and options. After naming the strings and rebooting the FPPD, it only shows "String Port #1-4" as a header. Everything else in that section has disappeared. 

~I have rebooted the Pi several times.
~Cleared Browser cache.
~Changed Screen res.
~Tried both Chrome and Edge.
Nothing has resolved the problem. 

Any recommendations?

[breese]

Very new device. Maybe try the zoom room.
https://zoom.us/j/175801909?pwd=ZU1hNzM5bjJpOGZ1d1BOb1BzMUFndz09

[JonD]

7.4 is older and the V2 is pretty new.  Might try updating to at least FPP 7.5 latest version. 

[CottonHeadedNinnyMuggis]

Using the Pi-Cap buttons, I reset ALL settings, Cycled the power, then repeated the exact same setup steps as before. This time, the settings area did not disappear. 

I then updated to 7.5 and the settings were still available.

I have found very little information about the Pi-Cap V2 and I'm not sure why i didn't start with the 7.5 update. Hopefully it was a fluke.....

Thanks for the help! 

[JonD]

I did not see any changes with 7.5 that would help, but occasionally just running updates again will resolve random issues.  It probably is not necessary, but I seem to have less issues if I reboot the FPP device a few minutes before I upgrade.  (just to clear any memory leaks or files that were left open)  Most do not do this and get along fine.