K8-B EEPROM Install?

[stanward]

I have a K8-B that I am trying to install FPP 6.3 onto it.  I am trying to figure out what cape to set it to.  I get an error message that it is unable to fetch GPIO info.

I tried installing the F8-B Virtual EEPROM but only to get the error message:

Upgrading firmware....
Blank EEPROM, overwriting=====
Running fppcapedetect:
Using /sys/bus/i2c/devices/2-0050/eeprom
EEPROM header miss-match
Finished, please reboot.

[Poporacer]

I tried installing the F8-B Virtual EEPROM

Why? I thought you said that you had a K8-B? They are not even the same manufacturer... Doing that will cause problems.

It sounds like you might have an incorrectly configured EEPROM, contact the Vendor or Dan Kulp to get the correct version.

[stanward]

I tried installing the F8-B Virtual EEPROM

Why? I thought you said that you had a K8-B? They are not even the same manufacturer... Doing that will cause problems.

It sounds like you might have an incorrectly configured EEPROM, contact the Vendor or Dan Kulp to get the correct version.

Reason I tried the F8-B was the instructions manual that Dan referenced on his site points to the F8-B-Manual.pdf file.  If there was a K8-B users manual, I wouldn't have tried that one.

[algerdes]

I fell for that as well. Set xLights to say it was an F8 instead of K8.  Not good.
Make sure your firmware matches your hardware.  Make sure your settings in the sequencer match as well.

As you now know, being directed to that manual was for functionality. 

[Sawdust]

.....I thought you said that you had a K8-B? They are not even the same manufacturer... Doing that will cause problems.

It sounds like you might have an incorrectly configured EEPROM, contact the Vendor or Dan Kulp to get the correct version.

Dan Kulp does have a F8-B.  Before he adopted the K, he was all F's. 

[Poporacer]

Dan Kulp does have a F8-B.  Before he adopted the K, he was all F's.

You are right, I was tired when I responded. He didn't make an F16-B... I should know I actually have 3 F8-B that were purchased in his initial Group Buy! 

[Poporacer]

Reason I tried the F8-B was the instructions manual that Dan referenced on his site points to the F8-B-Manual.pdf file.  If there was a K8-B users manual, I wouldn't have tried that one.

That makes sense..

[stanward]

I emailed Dan last night and he responded this morning with the proper EEPROM file.  Will give it a go after I finish work.  Thank you everyone!

[Poporacer]

No worries! Come back if you need anything else!