p10 panel not working with xlight output

[pennymoor]

Hi
Installed Fpp on my Pi3 with old adafruit matrix hat fitted setup the IP etc set up panels ran a test pattern on fpp ok,
ran a test pattern on xlights ok, turn on lights output in xlights nothing, download sequence to fpp and nothing, start channels etc check ok
Any ideas on what could be wrong as i have ha this panel working before and i have tried fpp version 6.2, 5.0 and 4.0
just in case.
Thank you
Mic

[breese]

Before you turned on output to lights in xLights, did you render the sequence?

[pennymoor]

yes i did

[rudybuddy]

Can you provide a screenshot of your matrix setup in xlights?

[Kensington Graves]

When I see this kind of problem on my equipment, it's almost always a mismatch between the channels assigned to the models in XLights and the channel outputs I have assigned to the controller in FPP.

[pennymoor]

picture of xlights setup and panel setup attached
Thanks
Mic