Abnormal conditions, received bridging data while sequence is running

[Paulanator]

I am using a Falcon Pi Hat and have set it up for angel wings with 5 buttons. I have that all working great.

My goal is to have the wings part of the show from the master controller and when someone pushes a button the wings stop the main sequence and run local static sequence for about 1 minute. That is working great. Then it goes back to the main show after the minute.

I am running the Pi Hat as a player, and it receives data from the show, then when a button is pushed the wings run the sequence for the button pushed.

The only little issue is that when the button is pushed the pi gets the error: Abnormal conditions, received bridging data while sequence is running.

If it seems to be working, is this ok to ignore?

I have seen a video where someone put a relay in on his setup, but mine seems to be working, but I was just concerned about any other issues I might be causing.

Thanks
Paul

[Poporacer]

I am running the Pi Hat as a player, and it receives data from the show

If it is a Player, that means that it is the "conductor" of the show and nobody should be telling him what to do. But you configured your Pi-Hat to also listen to the Show player. This is NOT a normal condition and that is the reason for the error message.
You probably want the Pi-Hat to be a Remote (AKA Listen for instructions from the show player). And then when a button is pressed, play the sequence that you want it to play and when it is done, revert to listening to the show player.

If it seems to be working, is this ok to ignore?

Possibly.

[Paulanator]

Thank you, that gives me some direction!