Pixie16 setup

[Ntjp]

Asked a question in FPP but should have asked it here. Need to setup a Pixie16 using XLights on a Pixie16.  The only answer I got before was did not think could do that because Pixie!6 was not DMX.  However the Pixie16 has a DMX switch setting.  I have tried several set ups but am only able to get the first 6 nodes on the strings to light up.  Please HELP   Surely there is one out there that has bought and setup a Pixie16....   

[Todd]

Are you sure your strings are set up properly in FPP?

[Ntjp]

As a followup for anyone reading this.  Got with LOR and the Pixie will only work with LOR.  It does not have DMX or E131.  So, a Pixie16 cannot be set up to run XLights.

[Todd]

Well that sucks.

[MARKB8080@gmail.com]

add it as a USB then to the right chor LOR as vendor and then model pixie 16 set your com port and most important the speed has to be 115200 and protocol needs to be Lor Optimized. make sure you got your Id set properly.

[k6ccc]

Running even a half way loaded Pixie 16 on a 115K network will choke the network very fast.  The rough rule of thumb for a LOR 115K non-enhanced network is about 900 channels.