Adding a rgb dumb controller setup

[bnldude]

My equipment includes a Raspberry Pi (FPP) connected to a Falcon controller (F4V3) and then to an LOR AC controller.  I would like to add my old 27ch dumb rgb controller to this setup but I only have the one dmx output on the F4V3.  Is there a way to use the other LOR rj 45 for connecting the dumb rgb controller? 

Thanks,
Larry

[JerryPlak]

you will need a Crossover cable to go from a LOR to RJ-45 to a DMX Devices

here's some info for you to look at
http://www.diylightanimation.com/wiki/index.php/Light-O-Rama_Controllers

[bnldude]

Since I have a xlr connector only on my dumb rgb controller am I correct in making a cable like the photo attached?

And since in my setup, the lor is universe 1, channels 1-16 would I just start with channel 17 on the dumb controller

LarryYou cannot view this attachment.

[JerryPlak]

Yes like the attached photo let say that you are using the 3 Pin XLR connector it's the same pins,
and just start with channel 17 on the dumb controlle.

[bnldude]

Awsome,
thanks Jerry