F16v4 with Smart Receiver v5.00

[Sinh2000]

I have a F16v4 and use 2 expansion boards to connect 8 smart receivers (none of them are daisy-chained).  All 8 SRs have been v 2.01.  One of these SRs died so I replaced it with a v5.00 SR.  Any tips on getting this to work?  I can't find any documentation.  When I hit the test button, all my lights work.  But I can't send a test signal through the F16v4 web site and no E1.31 data I send seems to get to the SR.  I have tried all the different roller settings.  Any help would be appreciated.  I have read about termination switches but can't find any dip switches on this board.

Thanks!

[JonD]

The Smart Receivers (SRs) are typically sent out in normal mode and terminated.  If you only have the one SR plugged in, it would need to be terminated.  I do not have any v5 series devices and can't give you any specific suggestions.  There typically is a legend printed on the back of the SR on how to configure.  I have had issues in the past when I could not get the SR to work in normal mode and had to use it Smart Mode.  Also, you can't trust the test function completely.  They are a great tool in the box, but there are known issues when testing does not work correctly. 

F16V4 Manual
https://docs.google.com/document/d/1449zGk1HEiQjcu6e98ebWnFBMFKUiXaFzis9QGAnfsk/edit?tab=t.0#bookmark=id.shn2jklimfn6

Receiver Specs
https://docs.google.com/spreadsheets/d/1fnxlPGnKqKpQdYMKxBcEzzGss37ireyOV2QQYhxMsbE

UPDATE: The specs may imply there are not any physical termination switches on the v5 SRs, but not sure what that means.
You cannot view this attachment.

[yarhoward]

The v5 doesn't have switches to terminate.  I'm assuming it's build in to the firmware.  You need to make sure the receiver has the most updated firmware.