DHCP wont connect

[MikeKrebs]

Checked it closely and appears to be soldered in - Darn.  And I still cant find this dam controller.  Not super smart on network so not sure if 192.168.1.50 will show up as my main network runs in 192.168.5.x. Wished I was sharper about the network side of this world

Normally, you can't get from a ".1" to a ".5". Put your PC on the same physical network as the controller. Change the IP on your computer to be a .1 address like 192.168.1.100. Then you can find the controller if it is on 192.168.1.50.

[JonD]

It does look like the OLED was an after thought and might have been soldered on the v2 series.  I think they are just a standard Arduino 7-pin 0.96 128X64 blue OLEDs.  You could probably pick some up from Ali Express without the pins already soldered in.  I am sure you could find a 7 way 7p female pcb header for them somewhere. This would be far above my pay grade, so do your own research.