Can't seem to get my network connections right.

[nealr48]

Trying to get up and running with a Raspberry 4B, FPP and F16V5. Can't seem to get the network settings right to get everything to talk together. Anyone live in the San Jose CA area able to help out me out? Willing to pay for your time.

Neal

[MikeKrebs]

Not there but a couple of questions. 

Are you wired or wireless? The reality is that you if you can be wired and use a switch, it is the easiest solution. Put everything on the same network and let the switch handle it for you. 

What is the problem you are having?

[nealr48]

Thanks for the reply.
I have an ATT supplied modem(192.168.1.254) with an Netgear orbi mesh system(10.0.0.1, 10.0.0.4, 10.0.0.. Network cable plugged into 10.0.0.8 from the Pi.  I definitely need to run on wifi but would like either option. When I try to setup a static connection then save, a message comes up about a conflict error and won't save. I figure somehow the mesh system is a problem but signal from the ATT wifi isn't strong enough to use. Any suggestions? The third node is 10.0.0.8. Don't know why it gets edited out.

[Poporacer]

This might help.
you stated that you want to run via Wi-Fi? Do you want to send show data via Wi-Fi? that can be problematic. Since you are spanning essentially 3 networks, it is a bit tricky.