Problems with FPP testing V2.01 receivers

[roberth58]

Any smart receiver plugged into a port on a K16 displays G,B,R,A instead of R,G,B,A when testing all channels. If I test a single model the order is correct. If the receivers are plugged into a differential expansion board attached to the K16 order is correct. Props plugged directly into the K16 are fine. Tried setting receivers to "0" and "A", changed RJ-45's, no  change. Receivers are not daisy chained and are terminated. Problem seems to be the 4 ports on the K16, hoping someone here can tell me what newbie mistake I made.

thanks

Bob

[roberth58]

I should have posted this in the beaglebone controller forum. If a mod would delete this I will post in the correct forum.

thanks