XLights not uploading all channels to FPP.

[JarrodWasHere]

Still stumped. Both test mode in FPP and XLights work. It also works when I play a sequence in XLights. I still cannot figure out how to make serial ports 2 through 16 valid. When I play a sequence in FPP. All the lights blink to match port 1 of my LOR controller.

[MikeKrebs]

In the visualizer, all the models should be on one serial port.

Really, visit the zoom. You will get help that save a lot of frustration and time.

[JarrodWasHere]

The one serial port did not work, thank you though. I will drop in the zoom sometime this week.

[JarrodWasHere]

I got it, I made a test sequence and it turns out that if you have an LOR controller, your sequences have to be 20 fps. And when exporting the .fseq file, it has to be V1 for the file.

[JarrodWasHere]

I've managed to run one LOR AC controller successfully, but the props I have take up 2 controllers, I've set up each unit id's in xLights and FPP and exported the models, but both controllers are getting confused when playing a sequence and start to do the same thing when each one has certain models assigned to them. How can I run both controllers and they know what models are assigned to them?

[MikeKrebs]

What do you have in FPP outputs?

[JarrodWasHere]

I have both controllers as the same outputs. LOR, TTYUSB0, active, and I set the unit id's as 5 and 4.