No Audio

[Steve]

Evening all,

I'm having issues getting audio out of the onboard 3.5mm jack and would be grateful for some help.

So I have a V4 Raspberry Pi fitted with a Falcon PiCap running FPP V7.5
Its set up using Cape Config: PiHAt (DPIPixels - allows onboard audio) and I'm running x300 pixels on one port with the sequence created in XLights.

Everything works well (thanks to all those that helped me previously) I just can't get any audio out of the 3.5mm Jack Socket.

Using the onboard sound is my prefered option as the set-up I have built runs using 5V usb power packs as its to be completely mobile as its part of a costume, audio is suppled by a USB speaker with a line-in connection (which also works fine)

I would be grateful if could give me a few pointers, things to check and try etc etc

Thanks in advance.
   

[AAH]

On the audio setup page have you selected the onboard audio?
Your playlist is including both the fseq files and the audio files?

[Steve]

On the audio setup page have you selected the onboard audio?
Your playlist is including both the fseq files and the audio files?

That's a good question where will i find the audio set-up page is it in FPP or on the Pi?

I did suspect it was a setting somewhere I had missed but I'm new to the audio bit.
Thanks for your help.

[zj023]

That's a good question where will i find the audio set-up page is it in FPP or on the Pi?

Select the Menu Status/Control then FPP Settings.  On that page there's an Audio/Video tab.  I think the Audio Output device defaults to HDMI so switch that to Headphones and Reboot the Pi.

[Steve]

All sorted thank you all!