FPP/F48

[kbtx@satx.rr.com]

Hi-I'm New to the hobby and no very little about Networks and computers but I'm trying to learn.
Here's where I'm at and looking for some help.
I was trying to set up a show network using FPP (Raspberry Pi 4). After network changes the fpp is communicating wirelessly and the f48 hard wired to the Fpp is responding. My problem is I can no longer see my F48 controller in my browser. Is there a setting I need to change on my Apple comp?? Any help I could get would be appreciated.

[Poporacer]

If you have a Show Network, then you need to provide a method for one network to be able to talk to the other network. This is normally done in one of 3 ways, but because you are on a Mac you are limited to only 2 ways. Create a Route in your Router or configure a Proxy Host. They each have benefits and limitations but the end result is that in the end they give you the results you need. It is covered in the FPP Manual https://falconchristmas.github.io/FPP_Manual(5.0).pdf#page=175

[kbtx@satx.rr.com]

Thank you for pointing me in the right direction.

[kbtx@satx.rr.com]

I guess I'm still lost.  I reset my F48. Re-configured My FPP see below. FPP connects to wifi but I can't see my F48 controller. Did I do something wrong in my setup? If I have to make changes in Mac to re route network I'm Lost. Again I have very little Knowledge of computers. I've read the FPP manual and watched videos on routing very confusing to me. Help!!

Wlan 192.168.1.225
        255.255.255.0
        192,168.1.1

Etho 192.168.225.2
        255.255.255.0
        Blank.             Gateway

F48 Controller 192.168.225.3
                     192.168.225.2 Gateway
                     255.255.255.0
                     192.168.225.2 Primary DNS

Host DNS 1.   192.168.1.1
       DNS 2    8.8.8.8

[kbtx@satx.rr.com]

I figured it out. Went into FPP Proxy setting and entered my F48 controller IP address.  Restarted FPP and controller. Went in to Proxy Settings and clicked on my controller IP address and what do you think popped up.  My F48 controller information.

[Poporacer]

I figured it out. Went into FPP Proxy setting and entered my F48 controller IP address.  Restarted FPP and controller. Went in to Proxy Settings and clicked on my controller IP address and what do you think popped up.  My F48 controller information.

I am glad it worked, I was pretty sure that was your problem but not know all of the details I couldn't be sure.

[kbtx@satx.rr.com]

Thanks Poporacer. It didn't click until this morning.