Falcon Christmas

Sequencers and Software Tools => XLights/Nutcracker => Topic started by: mattbaer on June 11, 2019, 07:03:26 PM

Title: Matrix help
Post by: mattbaer on June 11, 2019, 07:03:26 PM
This is all new to me. After reading and watching some videos. I have a matrix with 2" spacing 1152 total nodes power seems to be good. A test from the F16v3 everything looks good all nodes light. Test from xlights chase/twinkle looks good all nodes light. My issue is the first 50 nodes do not light when uploading xlights to fpp. In Xlights is set to 2 # strings 576 Nodes/strings 12 strands/strings F16v3 Port 1 and 2. Xlights used universe 1-7 each at 510 channels. FPP universe match xlights. Attached is the flag I was trying to have up for the 4th of July. I tried just a basic bar effect and the same everything but the first 50 light. I can't figure out what I might have wrong.
Title: Re: Matrix help
Post by: StickyWicket on June 11, 2019, 08:16:24 PM
Post screenshots of your configuration pages. Itís hard to troubleshoot without seeing the full picture of how things are setup.
Title: Re: Matrix help
Post by: mattbaer on June 11, 2019, 09:13:21 PM
Looks like I found my issue. Other Outputs Had an active with a start channel 1 and 150 count. Disabled and now it working.
Title: Re: Matrix help
Post by: Greg.Ca on June 12, 2019, 11:56:31 AM
Can you be more specific as what you did? Somewhat confusing. Thanks --Greg--
Title: Re: Matrix help
Post by: JonB256 on June 12, 2019, 04:35:48 PM
Looks like I found my issue. Other Outputs Had an active with a start channel 1 and 150 count. Disabled and now it working.

Because he had defined and made Active (in the Other Outputs Tab), the conflict was causing problems with 1 thru 150 on his matrix. (it was being re-directed)
Title: Re: Matrix help
Post by: mattbaer on June 12, 2019, 06:50:31 PM
I guess when I first set up FPP and playing around with the settings. I must have set created it and not realized it. I deleted it now. So I don't accidentally check the box again.
Title: Re: Matrix help
Post by: jnealand on June 13, 2019, 07:50:10 AM
Don't feel bad Matt, many of us have done that.  Me too.