Tune in sign and FPP

[stallionent]

Can FPP & F16V2 control this http://www.ebay.com/itm/271303628009?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

[mararunr]

12" x 3" red letter only sign....hmm...don't know the answer to your question but you could get a full color(rgb) P10 panel (12" x 6") for a lot less ($11.50) and it will run off FPP.

[CaptainMurdoch]

That looks like the panel that Dirk was playing with recently.

That display is not supported by FPP.  I probably wouldn't bother with it unless there is an existing library to support it.  It is single-color, less than half the size of a P10 panel, and for the same price plus shipping you could get at least 2 P10 panels.  The 12"x3" display isn't going to be readable from very far either.

[stallionent]

P10 panel (12" x 6") for a lot less ($11.50)

Have a link?, Thanks

[mararunr]

$10.50...https://www.crockettfantasyoflights.com/product/pre-sale-p10-matrix-panels/
$11.00...http://www.aliexpress.com/store/product/P10-rgb-SMD-3in1-full-color-indoor-LED-Display-screen-unit-board-32-16pixels-320mm-160mm/701799_866772137.html
$11.50...http://www.diyledexpress.com/index.php?main_page=product_info&cPath=75&products_id=455

[ThreeSizes]

You will also need a BeagleBone Black or Green running FPP and an Octosctroller cape to drive the P10 panel.

[stallionent]

I do have a Raspberry PI B+ extra, I can set it up as a slave? I'll probably need step by step instructions when the time comes.

Thanks, Dave

[Augus]

ref over at ACL http://auschristmaslighting.com/wiki/P10_Led_Panels
this is what I have book mark for later reading when I plan to do it.